Results
#1. Four forces P, 2P, 3P and 4P act along the sides, taken in order, of a square. The resultant force is
#2. A man stands on a spring weighing scale in a lift which carries him upward with acceleration. The reading on the weighing scale will be
#3. In a circular cylinder of mass m, radius r and length l, the moment of inertia with respect to central longitudinal axis would be
#4. A zero angle of friction implies that
#5. Two bodies of mass M and m are moving in a concentric orbit of radius R and r such that their periods are same. Te ratio between their angular velocity will be
#6. Brakes are applied to a car travelling at 90 Km/hr and comes to stop after 5 seconds. Assuming acceleration due to gravity as 10m/s², the coefficient of friction between the wheels and road surface is closed to
#7. The stress-strain curve for glass during tensile test would exhibit
#8. A solid circular shaft is subjected to a maximum shear stress of 140 MPa. The magnitude of maximum normal stress developed in the shaft is
#9. In a thin cylindrical pressure vessel, the ratio of maximum shear stress to hoop stress is
#10. A simply supported beam carries several concentrated loads. The shear force would be maximum
#11. Torsion rigidity of a solid circular shaft of diameter d and length l, shear modulus G and polar moment of inertia J has been subjected to torque T, will be
#12. Which of the following sections will be best in torsion
#13. In a circular shaft, the condition when maximum bending stress is equal to maximum shear stress developed is (in terms of Bending moment M and torque T )
#14. The ratio of actual damping coefficient to the critical damping coefficient is known as
#15. A Davis steering gear consists of four bar mechanism with
#16. An idler pulley is used
#17. The function of flywheel is
#18. The product of circular pitch and diametral pitch equals
#19. The maximum efficiency of a screw jack provided with square threaded screw (angle of friction = 30⁰) will be
#20. During the dwell period of cam, the follower
#21. Identify the hardest metal
#22. Maximum surface hardness is attained by
#23. Aeroplane and certain automobile parts are usually made of
#24. Killed steels
#25. The chemical formula for cementite is
#26. Which of the followings are not the neutral refractory material
#27. An allen bolt is provided with
#28. The flanges of a flange coupling are coupled together by means of bolts and their number depends upon
#29. A hydrodynamic lubricated bearing is one which
#30. A rope has been designated as 6 by 19 wire rope. The numbers 6 and 19 respectively stand for :
#31. A connecting rod should be
#32. The property of a material by which it can be rolled into sheets is called
#33. The main constituent of moulding sand is
#34. Wax pattern is used in
#35. Which process of welding is used for car bodies
#36. Tapping is the operation of
#37. Capillary action is due to
#38. Steady flow occurs when
#39. The displacement thickness for a boundary layer
#40. The wake region
#41. Dynamic similarity between model and prototype implies that
#42. A Kaplan turbine blade is suitable for
#43. Which one of the following characteristic does not change during a reversible adiabatic process
#44. Orsat apparatus is meant for
#45. Which air standard cycle consists of two isothermals connected by two constant volume processes
#46. A particular firing order is necessary in a multi-cylinder engine so as to
#47. When a petrol engine is supplied with diesel fuel
#48. The clutch is located between the engine and
#49. The function of a shackle with a leaf spring is to
#50. What material is a brake lining usually made of
#51. In a sample of wet steam, mₛ and m_w are mass of steam and water respectively, then the dryness fraction of a steam is given by
#52. Mollier diagram is a plot of
#53. Which of the following fitting is a boiler mounting
#54. What is the function of steam trap
#55. Which one of the following statement is incorrect statement
#56. As steam glides over the moving blades of a reaction turbine
#57. The overall efficiency η₀, in term of stage efficiency ηₛ and reheat factor R is
#58. An ideal Brayton cycle consists of
#59. Propulsion efficiency of a jet engine is given by
#60. Upto the critical radius of insulation
#61. If the temperature of a hot body is increased by 50%, the amount of radiation emitted by it would increase by nearly
#62. The normal automobile radiator is a heat exchanger of the type
#63. During refrigeration cycle based on vapour compression system, the heat is rejected by the refrigerant in
#64. The chemical formula of Freon-12 is
#65. When the temperature of air is reduced by continuous cooling at constant pressure, the condensation of water starts at a particular temperature known as
#66. Desert coolers are suitable for hot and dry outside conditions because
#67. In ABC analysis, __________________ class of elements are generally large in number
#68. At the break-even point
#69. Quasi-equilibrium process is defined as:
#70. Which of the following parameter is a path function ?
#71. In power plants, Deaerator is placed at a height above the feed water pump because it
#72. Surface plate is usually made of grey cast iron because it provides
#73. In a damped vibration system, the damping force is proportional to
#74. The cooling of water in the wet cooling tower takes place with the following mechanism:
#75. The ratio of work done by first and second row of 2 row Curtis turbine is:
#76. A long blade of steam turbine is twisted to ensure
#77. When the heat is transferred by molecular movement and the movement is caused due to density difference, the mode of heat transfer is called
#78. The ratio of heat flow Q₁/Q₂ from two walls of same thickness and temperature difference having their thermal conductivities as K₁=3K₂ will be
#79. According to 2011 census what is the density of population in Lahaul-Spiti district of H.P.?
#80. According to 2010-11 agriculture census in which district of H.P. the average size of operational holdings is largest?
#81. According to 2011 census which district of H.P. had the lowest rural literacy rate?
#82. Which district of H.P. had the highest Scheduled Tribe population in the State (2011 census)?
#83. Who was the leader of opposition in the H.P. Territorial Council during 1957?
#84. In which district of H.P. is Sukhsar lake?
#85. In which district of H.P. is Kais sanctuary?
#86. Which is the highest hockey ground in H.P.?
#87. Which of the following was once the capital of Kehlur (Bilaspur) princely State?
#88. Who is author of the book ‘Shimla Past and Present”?
#89. There are two Rashtriya Military Schools in Rajasthan. One is at Ajmer. Where is the other?
#90. Aam Aadmi Bima Yojna is being implemented by _________________.
#91. Rajiv Gandhi National Aviation University is situated at __________________.
#92. In which year was sugar sector de-regulated in India?
#93. The father of Homeopathy was a physician who belonged to _____________.
#94. What is the capital of Indonesia?
#95. When was Magna Carta signed by the king of England?
